Operation process of pipe bending machine (1)

Operation process of pipe bending machine (1)

Tube regularization

When designing and arranging pipes, it is necessary to avoid too large arc, arbitrary curve, compound bending and greater than 180. Arc. Too large arc not only makes the tooling bulky, but also is limited by the size of the bending machine; the arbitrary curve and composite bending design modeling is very unreasonable, which greatly hinders the mechanization and automation production, and makes it difficult for the operator to get rid of the heavy physical labor; it is greater than 180. The circular arc of the pipe bender makes the mold impossible.

Standardization of bending radius

The first mock exam should be done as the first mock exam and the multi tube one mold as far as possible. For the first mock exam, there is only one bend radius in any bending and bending angle, because the bending machine does not replace the module in bending process. This is "one tube one mold". The first mock exam is the same diameter of pipe, which means that the same type of module can be used to bend different shapes of tubes so that the number of modules can be reduced.

The pipe bending machine JGWG-40Z,JGWG-50Z,JGWG-80Z,JGWG-110Z and other models produced by Zaozhuang Make Machinery Co., Ltd. are on sale!

Welcome new and old customers to consult!