(1) Oiling lubrication: the guide surface of the large, medium and small slides on the guide rail surface of the bed is lubricated with oil pot, once per shift.
(2) Splash lubrication: inside the lathe gear box, inside the headstock, usually replaced once every three months.
(3) Lubrication of oil lining: Lubrication in the feed box of the lathe, put the wick in the groove and lead to the required lubrication part.
(4) Lubricating oil cup lubrication: lathe tailstock, medium and small skateboard rocker handle to rotate the bearing part.
(5) Grease cup lubrication: the intermediate gear of the lathe hanging wheel box.
(6) Pay attention to check whether the oil quantity of each lubrication part is sufficient or leaks when going to work.
Previous: Horizontal lathe maintenance