Lifting and installation of hydraulic press bending

Lifting and installation of hydraulic press bending 

1. The center of gravity of the whole hydraulic plate bending machine is high, the front is heavy and the rear is light. Therefore, attention must be paid to the position of the center of gravity in the process of lifting, handling and installation, so as to avoid the machine turning over accident. During lifting, the angle of lifting steel wire should be as small as possible to ensure the accuracy of the machine tool unchanged.

2. The left and right columns of the hydraulic plate bending machine are located at the working table as the benchmark of the measurement level, and the vertical and horizontal directions shall be less than or equal to 1000:0.2. According to the foundation drawing, the foundation shall be prepared in advance, the hydraulic plate bending machine shall be installed on the foundation, and the anchor bolts shall be installed at the same time. Finally, the grouting shall be conducted. After the cement is completely solidified, the bolts shall be tightened and the level shall be checked.

Pressure adjustment of hydraulic bending machine

The calculation pressure of hydraulic bending machine is based on the tensile strength of the plate. If you have different board functions, of course accounting out the same, but the force of practical needs is different.

2 if the external factors are the same, only the problem of hydraulic bending machine can be adjusted through two local adjustments: one is to adjust the tensile strength of the inner plate of the system; the other is to adjust the Da value in the system setting.

Zaozhuang Make Machinery Co., Ltd. hydraulic press HPB-100，HPB-150，HPB-300 and other models,  welcome to buy!