Safety Operating Regulations for Lathes of Zaozhuang Make Machinery Co., Ltd.

Zaozhuang Make Machinery Co., Ltd. reminds you that the safe operating procedures for lathes are as follows:

1. Before operation, wear tight protective clothing, fasten the cuffs, do not open the hem of the jacket, and strictly prohibit wearing gloves. Do not wear, take off, or wrap your clothes around the machine to prevent the machine from being twisted. You must wear a safety helmet, braids should be put in the hat, and no skirts or slippers are allowed. Wear protective goggles to prevent the eye from flying iron chips.

2. Before starting the lathe, you must wear labor protection products according to the requirements of safe operation. You must carefully check whether the parts and protective devices of the machine tool are intact, safe and reliable. Lubricate the machine tool and run it at low speed and no-load for 2-3 minutes. To check whether the machine is running normally.

3. When loading and unloading chucks and large parts, check that there are no obstacles around, padded wooden boards to protect the bed surface, and block, support and set up well. When the car is heavy, it must be balanced according to the weight and the workpiece. The clamping of the tool and the tool should be tightened to prevent the workpiece or tool from flying out of the fixture, and the chuck wrench and socket wrench should be taken off.

4. When the machine tool is running, it is strictly prohibited to wear gloves to operate; it is strictly forbidden to touch the rotating part of the machine tool by hand; it is strictly forbidden to transfer objects through the lathe during the operation of the lathe. Stop loading and unloading workpieces, installing tools, refueling and cleaning chips. Use a brush or hook to remove iron filings, and it is forbidden to clean it by hand.

5. When the machine tool is running, it is not allowed to measure the workpiece, and it is not allowed to brake the rotating chuck by hand; when using sandpaper, it should be placed on the file, and it is strictly forbidden to use the sandpaper with gloves. The worn sandpaper is not allowed to be used or used For files without handles, do not use the front and back brakes as brakes, and should go through the intermediate braking process.

6. The cutting amount of the processed workpiece should be selected according to the technical requirements of the machine tool to avoid accidents caused by overload of the machine tool.

The lathes KE1-60, KE2-80, KE2-100, etc. produced by Zaozhuang Make Machinery Co., Ltd. are all high-precision horizontal lathes, which occupy a small area, are easy to operate, and have multiple uses in one machine. Welcome customers to consult and purchase!

(Updated part two tomorrow)