Notes for power press operation

Power Press before work

(1) check the lubrication of each part, and make the lubrication point to get sufficient lubrication

Check whether the mold installation is correct and reliable;

Check whether the compressed air pressure is within the specified range

Check whether the switch button is sensitive and reliable, be sure to make the flywheel and clutch off, to open the motor;

Make the press to carry out several times of empty stroke, check the brake, clutch and operating part of the work

Check the main motor for abnormal heat, abnormal vibration, abnormal sound, etc

Add lithium ester oil to the slider by hand pump

Checking and adjusting feeder roller clearance to being the technological requirement

'levies to check and keep the oil mist, oil amount to specified requirements

⑽ motor start, should check whether the flywheel rotating direction is the same as the rotary marks.

The power press is working

The lubrication oil shall be sent to the lubrication point by the manual lubricating oil pump on a regular basis

Do not adjust the press without authorization when you are not familiar with the performance of the press

It is absolutely forbidden to cut two layers of sheet material at the same time

If you find that the work is abnormal, you should stop working immediately and check in time.

Power press after work

Make the flywheel and clutch off, cut off the power supply, release the remaining air

Wipe the press clean, the countertop rust oil

Keep records after each run or maintenance.

Zaozhuang make machinery co., ltd., production of the power press are of good quality, we are committed to providing customers with better products and services, we have many types of punching machine for production such as JH21, JC21S, JB23, J21S, JC21, J21 serial open-style, etc, can satisfy the needs of different customers, welcome new and old customers to come to the choose and buy!